In short
- An EAS antenna detects an active security label or hard tag and alerts staff with sound and light.
- The two main technologies are AM (58 kHz) and RF (8.2 MHz). Antennas and the tags on your goods must use the same technology.
- The type is chosen by entrance width, goods and store design: pedestal antennas, floor antennas, ceiling antennas or door-side antennas.
- Peran d.o.o. sells, installs and services Sensormatic EAS antennas, and also services systems installed by other contractors.
Types of EAS antennas
There is a suitable type for every entrance, from classic pedestals to fully concealed systems.
Pedestal antennas
The most common type: antennas stand beside the entrance and customers walk between them. Available in several designs and heights, depending on the model.
Floor antennas
A concealed system under the floor at the entrance, so the entrance stays completely clear. Easiest to install during a fit-out, before the final floor finish.
Ceiling antennas
A concealed system above the entrance, for stores that want an open entrance with nothing on the floor. Options depend on ceiling height and the system.
Door-side antennas
Narrower antennas along a door or shop-window frame, for entrances without room for classic pedestals.
Antenna installations



How to choose EAS antennas
Measure the entrance
The entrance width determines the number of antennas and the spacing between them. Wide entrances get several antennas in a row or a concealed system.
Check the surroundings
Metal doors, shutters, checkouts and electronics near the entrance can affect detection, especially with RF. That is why we set antenna positions on site.
Choose the technology
AM is usually more reliable for goods containing metal and for wider entrances, while RF uses thinner, cheaper labels. If you already have tags, new antennas are chosen to match them.
AM and RF compared →Decide on extra features
Depending on the model, antennas can count visitors, warn about foil-lined bags and log alarms for later analysis.
Questions retailers ask us
How wide an entrance can EAS antennas cover?
It depends on the technology, the antenna model and the tags you use. A narrow entrance is covered by one pair of antennas; wider ones get several antennas in a row or a concealed system. We set the exact layout after seeing the entrance.
Can antennas stand next to automatic or metal doors?
Yes, but nearby metal and door motors can affect detection. We therefore set the antenna position on site and tune the system after installation.
Will new antennas work with our existing labels and hard tags?
Yes, if they use the same technology (AM or RF). AM antennas do not detect RF tags and vice versa, so we check what you already use before quoting.
Why does the exit alarm go off for no reason?
The most common causes are a label that was not deactivated, a tag the manufacturer built into the product, or interference from equipment near the entrance. When servicing, we check the antennas and the checkout equipment together.
Do antennas need power and cables in the floor?
Antennas run on mains power. With pedestal antennas, cables usually run through the floor in front of the entrance; we agree the cable route before installation.
Do you service antennas installed by another contractor?
Yes. We also service systems installed by other contractors. We reach any part of Croatia within 24 hours if the fault is reported by 8:15.
